Originally Posted by Dr.AndyDVM
What am I missing? Do these things work with NRS towers? The threaded part stops before the bottom of the tower bushing. Attachment 11235
Sent from my iPhone using Mountain Buzz
If this were my set up, would consider putting some type of spacer between the top of the oarstand and horns just enough to raise the threads to the bottom of the oarstand, then get a wrench and tighten the stainless steel locknut to the point that it is about 1/2 turn from being too tight to allow the oarlock to move freely. Make sense??
It is unfortunate, but not all oarstands will work with the threaded cobra's without some modifications.
If you need some advice on tuning the cobra's to your oars, let me know....I can walk you through what is correct. Worked at Sawyer for a number of years and have it pretty dialed!