Originally Posted by ClancyBallz
So I am interested in a custom dry box and I know all rafts are different but...
Do I make it the maximum width, tight fit between the tubs, similar to my cooler? Or a few inches narrower to keep from rubbing the tubes? Is there an pinch points to worry about?
Depends on your confidence in the mfg to make a smooth weld and your ability to keep nicks out of the sides and corners of your box
There should not be much rubbing going especially when everything is strapped --- but if you are worried then get them an inch narrower than your tubes width, or go tight and glue a wear strip inside your boat